Vehicle temperature identification based on vehicle dimensions during vehicle parking
Keywords:
Vehicle temperature, Vehicle dimension, ThermocoupleAbstract
Increased car temperature when parked in sunlight results in discomfort for the driver and passengers, and can damage the inside the car, including the dashboard, seats, and control panel. Research This study was conducted to measure the increase in vehicle cabin temperature when parked in the sun from 08.20 - 16.20 WIB. This research aims to compare the test results between the two objects studied, namely cabin temperature increase in avanza type G 1.3 year 2010 and innova type G 2.0 year 2010. Data was collected using data logger gauges placed at four points in the vehicle cabin. four points in the vehicle cabin. The results showed that the highest cabin temperature was achieved by the Avanza vehicle with the highest hot spots at sensor 1 and sensor 2, while the highest CO levels were at a certain point during the test. The dimensional factor of the vehicle was shown to affect the temperature rise and heat distribution in the cabin. The implication of this research is the need to develop vehicle thermal management technology to reduce the impact of extreme heat on the cabin as well as health risks due to toxic gases.
References
[1] F. Purwanto, “Perancangan dan Implementasi Sistem Monitoring Gas Berbahaya pada Mobil berbasis Logika Fuzzy Menggunakan Mikrokontroler,” e-Proceeding of Engineering : Vol.3, No.3 December 2016, vol. 3, p. 4657, 2016.
[2] M. Setiyo, B. Waluyo, N. Widodo, M. L. Rochman, S. Munahar, and S. D. Fatmaryanti, “Cooling effect and heat index (HI) assessment on car cabin cooler powered by solar panel in parked car,” Case Studies in Thermal Engineering, vol. 28, no. August, p. 101386, 2021, doi: 10.1016/j.csite.2021.101386.
[3] G. J. Marshall, C. P. Mahony, M. J. Rhodes, S. R. Daniewicz, N. Tsolas, and S. M. Thompson, “Thermal Management of Vehicle Cabins, External Surfaces, and Onboard Electronics: An Overview,” Engineering, vol. 5, no. 5, pp. 954–969, 2019, doi: 10.1016/j.eng.2019.02.009.
[4] A. Nur Setya Budi, I. Qiram, and D. Sartika, “Pengaruh Prosentase Kepekatan Kaca Film Terhadap Distribusi Termal dan Pencahayaan Kabin Kendaraan,” V-MAC (Virtual of Mechanical Engineering Article), vol. 6, no. 1, pp. 1–4, 2021, doi: 10.36526/v-mac.v6i1.1293.
[5] Sugiyono, Metode Penelitian Kuantitatif, Kualitatif Dan R&D. 2017.
Downloads
Published
Conference Proceedings Volume
Section
License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.