Design and development of a portable diagnostic tester for fault detection in EFI vehicle control systems

Design and development of a portable diagnostic tester for fault detection in EFI vehicle control systems

Authors

  • Dwi Sudarno Putra Universitas Negeri Padang
  • Joe Vane N. Antifuesto University of Science and Technology of Southern Philippines
  • Budi Utomo Wisesa Universitas Negeri Padang
  • Zainul Hamidi Universitas Negeri Padang
  • Mutiara Vinta Universitas Negeri Padang

Keywords:

Portable diagnostic tester, Electronic fuel injection, Fault detection, OBD systems, Automotive diagnostics

Abstract

The evolution of automotive technology has significantly advanced with the adoption of Electronic Fuel Injection (EFI) systems, which offer superior fuel efficiency, environmental friendliness, and enhanced vehicle performance compared to traditional carburetor systems. However, the complexity of EFI systems necessitates sophisticated diagnostic tools, often inaccessible to small-scale workshops due to high costs and proprietary limitations. This study presents the design and development of a Portable Diagnostic Tester as an affordable and effective alternative for diagnosing faults in EFI control systems, compatible with both OBD I and OBD II systems. The Portable Diagnostic Tester was constructed using an ATMega 8 microcontroller, a 16x2 LCD display, photodiode sensors, and supporting circuitry. It decodes engine trouble codes via onboard diagnostics, displaying fault information with improved accuracy over manual methods. Testing was conducted on various EFI vehicles, demonstrating the Portable Diagnostic Tester's reliability in identifying issues such as sensor malfunctions. Notably, the device performed optimally under low-light conditions, with daytime performance affected by ambient light interference. The Portable Diagnostic Tester 's simplicity, cost-effectiveness, and accessibility provide a viable solution for small workshops, enabling efficient diagnosis of EFI issues without reliance on high-cost scan tools. Future enhancements could include extended compatibility, user-friendly interfaces, and additional functionalities to rival commercial diagnostic tools.

References

[1] V. V. Pham and D. T. Cao, “A brief review of technology solutions on fuel injection system of diesel engine to increase the power and reduce environmental pollution,” Journal of Mechanical Engineering Research and Developments, vol. 42, no. 1, pp. 1–9, 2019, doi: 10.26480/jmerd.01.2019.01.09.

[2] R. Patil, “Electronic fuel injection,” SAE Technical Papers, pp. 1–6, doi: 10.4271/820903.

[3] B. Mahr, “Future and Potential of Diesel Injection Systems,” Thermo- and Fluid Dynamic Processes in Diesel Engines 2, pp. 3–17, 2004, doi: 10.1007/978-3-662-10502-3_1.

[4] K. V. M. K. Reddy, B. M. Reddy, K. C. S. Reddy, P. Kartheek, and T. S. Adarsh, “Comparative investigation of electronic fuel injection in two-wheeler applications: A Review,” IOP Conf Ser Mater Sci Eng, vol. 1116, no. 1, p. 012073, 2021, doi: 10.1088/1757-899x/1116/1/012073.

[5] A. Namigtle-Jiménez, R. F. Escobar-Jiménez, J. F. Gómez-Aguilar, C. D. García-Beltrán, and A. C. Téllez-Anguiano, “Online ANN-based fault diagnosis implementation using an FPGA: Application in the EFI system of a vehicle,” ISA Trans, vol. 100, no. xxxx, pp. 358–372, 2020, doi: 10.1016/j.isatra.2019.11.003.

[6] H. L. Gelgele and K. Wang, “An expert system for engine fault diagnosis: Development and application,” J Intell Manuf, vol. 9, no. 6, pp. 539–545, 1998, doi: 10.1023/A:1008888219539.

[7] B. I. Ele, S. I. Ele, and A. O. Ofem, “Development of an Intelligent Car Engine Fault Troubleshooting System (CEFTS),” West African Journal of Industrial and Academic Research, vol. 16, no. 1, pp. 38-50–50, 2016.

[8] D. Du, X. Guo, and Q. Guan, “A fault diagnostic method for EFI engine based on MATLAB software package,” Proceedings - International Conference on Intelligent Computation Technology and Automation, ICICTA 2008, vol. 2, pp. 870–874, 2008, doi: 10.1109/ICICTA.2008.97.

[9] Y. S. Yaras et al., “Disposable cartridge biosensor platform for portable diagnostics,” Optics and Biophotonics in Low-Resource Settings III, vol. 10055, no. March 2017, p. 100550O, 2017, doi: 10.1117/12.2254729.

[10] S. K. Singh and A. K. Singh, “A study: OBD III standard and its predecessors OBD II and OBD I,” pp. 0–2.

[11] T. Deshpande and N. Jadhav, “Active Cell Phone Detection and Display Using Atmega-8 Microcontroller,” Int J Res Eng Technol, vol. 3, no. 8, pp. 2321–8843, 2015.

[12] T. Clarke, “The EAGLE Schematic & PCB Layout Editor - A Guide,” Most, no. November, pp. 1–12, 2011.

[13] C. Computer, “Eagle Tutorial,” 2014.

[14] M. Iqbal Ash Shiddiqy, “Performance Analysis of LDR, Photodiode, and BH1750 Sensors for Sunlight Intensity Measurement in Open Areas,” Signal and Image Processing Letters, vol. 6, no. 1, pp. 11–26, 2024.

Downloads

Published

2025-05-31

How to Cite

Design and development of a portable diagnostic tester for fault detection in EFI vehicle control systems. (2025). BIS Energy and Engineering, 2, V225043. https://doi.org/10.31603/biseeng.368

Most read articles by the same author(s)

Similar Articles

1-10 of 43

You may also start an advanced similarity search for this article.